27
Privilege Requirement
None.
Example
Display the information of vlan 5:
T1600G-52TS(config)# show vlan id 5
3.9 show interface switchport
Description
The show interface switchport command is used to display the IEEE 802.1Q
VLAN configuration information of the specified port/LAG.
Syntax
show interface switchport [ gigabitEthernet
port
| port-channel
lagid
]
Parameter
port
—— The port number.
lagid
—— The ID of the LAG.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the VLAN configuration information of all ports and LAGs:
T1600G-52TS(config)# show interface switchport
To Next Page
Loading...
