138
9.2.2 Port Config
On this page you can configure MLD snooping function with each single port.
Choose the menu Multicast→MLD Snooping→Port Config to load the following page.
Figure 9-14 Port Config
The following entries are displayed on this screen:
Port Config
UNIT/LAGS Click unit number to configure the physical ports of this unit
member. Click LAGS
to configure the link aggregation
groups.
Select:
Select the port you want to configure.
Port: Displays the port number.
MLD Snooping: Select Enable/Disable MLD snooping for the desired port.
Fast Leave:
Select Enable/Disable Fast Leave feature for the desired
port. If Fast Leave is enabled for a port, the switch will
immediately remove this port from the multicast group upon
receiving MLD done messages.
LAG: Displays the LAG number.
To Next Page
Loading...
