TP-Link T1700G-28TQ - 6.2 Link Aggregation Group (LAG)

53
Choose the menu Stack Management→Stack Config to load the following page.
Figure 5-8 Stack Config
The following entries are displayed on this screen:

Provision Info
Unit ID: Configure the unit number of the provisioned stack member.
Device Type: Specify the device type of the provisioned stack member.

Stack Member Config
Unit ID
：
Displays the switch member’s current unit number.
New Unit ID: Configure the new unit number of stack member.
The new unit
number will go into effect after this stack member’s next start up.
Role: Di
splays the role of the switch in the stack, either Master or
Member.
MAC Address The switch member’s MAC address is its unique identification.