TP-Link T2500G-10TS - Chapter 30 DLDP Commands; Dldp(Global); Dldp Interval

Chapter 30 DLDP Commands
DLDP (Device Link Detection Protocol) is used to monitor the link state of fiber-optic or
twisted-pair Ethernet cables. When a unidirectional link is detected, the corresponding port will
be shut down automatically or manually (depending on the shut mode configured).
30.1 dldp(global)
Description
The dldp command is used to enable the DLDP function globally. To disable it,
please use no dldp command.
Syntax
dldp
no dldp
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Enable the DLDP function globally:
T2500G-10TS(config)# dldp
30.2 dldp interval
Description
The dldp interval command is used to define the interval of sending
advertisement packets on ports that are in the advertisement state.
Syntax
dldp interval interval-time
Parameter
interval-time —— The interval of sending advertisement packets. It ranges
from 1 to 30 seconds. By default, it is 5 seconds.
244