128
9.1.2 VLAN Config
Multicast groups established by IGMP Snooping are based on VLANs. On this page you can
configure different IGMP parameters for different VLANs.
Choose the menu Multicast→IGMP Snooping→VLAN Config to load the following page.
Figure 9-6 VLAN Config
The following entries are displayed on this screen:
VLAN Config
VLAN ID:
Enter the VLAN ID to enable IGMP Snooping for the desired
VLAN.
Router Port Time:
Specify the aging time of the router port. Within this time, if the
switch doesn’t receive
IGMP query message from the router
port, it will consider this port is not a router port any more.
Member Port Time:
Specify the aging time of the member port. Within this time, if
the switch doesn’
t receive IGMP report message from the
member port, it w
ill consider this port is not a member port any
more.
Leave Time:
Specify the interval between the switch receiving a leave
message from a host and the switch removing the host from the
multicast groups.
Static Router Ports: Enter the static router port
which is mainly used in the network
with stable topology.
VLAN Table
VLAN ID Select: Click the Select button to quick-
select the corresponding VLAN
ID based on the ID number you entered.
To Next Page
Loading...
