TP-Link T2500G-10TS - Page 140

130
Choose the menu Multicast →IGMP Snooping →Port Config to load the following page.
Figure 9-7 Port Config
The following entries are displayed on this screen:

Port Config
Port Select: Click the Select button to quick-
select the corresponding port
based on the port number you entered.
Select:
Select the desired port for IGMP Snooping feature
configuration. It is multi-optional.
Port:
Displays the port of the switch.
IGMP Snooping:
Enable/Disable IGMP Snooping for the desired port.
Fast Leave: Enable/Disable
Fast Leave feature for the desired port. If Fast
Leave is enabled for a port, the switch will immediately remove
this port from the multicast group upon receiving IGMP leave
messages.
Filter:
Enable/Disable multicast filtering feature on the port.
Action Mode:
Select the action mode to process multicast packets when the
multicast IP is in the filtering IP-range.
 Permit: Only the multicast packets whose multicast IP is in
the IP-range will be processed.

Deny: Only the multicast packets whose multicast IP is not
in the IP-range will be processed.
Bound IP-Range
(ID):
Enter the IP-range ID the port w
ill be bound to. The binding
IP-
range IDs of the port can be cleared by entering null value in
this field and click Apply button to submit the configuration.
Max Groups:
Specify the maximum number of multicast groups to prevent
some ports taking up too much bandwidth.
LAG:
Displays the LAG number which the port belongs to.