TP-Link T2500G-10TS - Static Multicast IP

135
Step
Operation
Description
4
Enable Multicast
VLAN
Enable Multicast VLAN, configure the VLAN ID of a multicast
VLAN as 3 and keep the other parameters as default on
Multicast→IGMP Snooping→Multicast VLAN page.
5
Check Multicast
VLAN
3-5 and Multicast VLAN 3
will be displayed in the IGMP
Snooping Status table on the Multicast→IGMP
Snooping→Snooping Config page.
9.1.6 Static Multicast IP
Static Multicast IP table, isolated from dynamic multicast group and multicast filter, is not
learned by IGMP Snooping. It can enhance the quality and security for information transmission
in some fixed multicast groups.
Choose the menu Multicast→IGMP Snooping→Static Multicast IP to load the following page.
Figure 9-10 Static Multicast IP Table
The following entries are displayed on this screen:

Create Static Multicast
Multicast IP:
Enter static multicast IP address.
VLAN ID:
Enter the VLAN ID of the multicast IP.
Forward Port:
Enter the forward port of the multicast group.