TP-Link T2500G-10TS - Page 147

137
Choose the menu Multicast→IGMP Snooping→IGMP Snooping Querier to load the following
page.
Figure 9-11
Packet Statistics
The following entries are displayed on this screen:

IGMP Snooping Querier Config
VLAN ID:
Enter the ID of the VLAN that enables IGMP Snooping Querier.
Query Interval:
Enter the time interval of sending a general query frame by IGMP
Snooping Querier.
Max Response
Time:
Enter the maximal time for the host to respond to a general
query frame sent by IGMP Snooping Querier.
General Query
Source IP:
Enter the source IP of the general query frame sent by IGMP
Snooping Querier. It should not be a multicast IP or a broadcast
IP.
Last Member Query
Interval:
Enter the time interval of sending specific query frames by IGMP
Snooping Querier. A specific query will be sent on condition that
"fast-leave" is not enabled and a leave frame is received.