TP-Link T2500G-10TS - VLAN Config

144
Last Listener Query
Interval:
Enter the Last Listener Query interval time. When the multicast
g
roup has no more member ports, it will send the Specific
Query Message with this interval time to check whether there
is another listener.
Last Listener Query
Count:
Enter the Last Listener Query numbers. When the multicast
group has no more member ports,
it will send this numbers of
Specific Query Message to check whether there is another
listener.
Multicast VLAN:
Enable or disable multicast VLAN function. When multicast
VLAN is enabled, all multicast data will forward in this VLAN if
this port belongs to the VLAN.
Multicast VLAN ID:
Enter the multicast VLAN ID.
Note:
1. When Unknown Multicast Filter is configured, the Unknown Multicast function in IGMP
Snooping is also configured at the same time.
2. Configurations of the Router Port Aging Time and Member Port Aging Time in 9.2.2 VLAN
Config override their global configurations here.
3. Before creating the Multicast VLAN, its corresponding VLAN should be configured in 9.2.2
VLAN Config.
9.2.2 VLAN Config
On this page you can configure MLD Snooping function with each single VLAN. You need to
create VLAN if you want to enable MLD Snooping function in this VLAN.
Choose the menu Multicast→MLD Snooping→VLAN Config to load the following page.
Figure 9-15 VLAN Config
The following entries are displayed on this screen:

VLAN Config
VLAN ID:
Enter the VLAN ID you want to configure.
Router Port A
ging
Time:
Enter the router port aging time for this VLAN. It will override
the global configured aging time.