TP-Link T2500G-10TS - Querier Config

148
Choose the menu Multicast→MLD Snooping→Static Multicast to load the following page.
Figure 9-18 Static Multicast
The following entries are displayed on this screen:

Static Multicast Config
VLAN ID:
Enter the VLAN ID.
Multicast IP:
Enter the multicast IP address.
Member Ports:
Enter the member ports of the static multicast
group.

Static Multicast List
Select:
Select the static multicast group you want to
change.
VLAN ID:
Displays the VLAN ID.
Multicast IP:
Displays the multicast group IP address.
Member Ports:
Displays the member ports of the static multicast
group.
9.2.6 Querier Config
In an IPv6 multicast network that runs MLD, a Layer 3 multicast device works as an MLD querier
to send out MLD queries and manage the multicast table. But MLD is not supported by the
devices in Layer 2 network. MLD Snooping Querier can act as an MLD Router in Layer 2
network. It can help to create and maintain multicast forwarding table on the switch with the
Query messages it generates.