TP-Link T2500G-10TS - Rear Panel

8
Name
Status
Indication
SFP1, SFP2
On
A 1000Mbps device is connected to the
corresponding port, but no activity.
Flashing
Data is being transmitted or received.
Off
Not linked.
 Console (RJ-45) Port: Designed to connect with the serial port of a computer or terminal
for monitoring and configuring the switch.
 Console (USB) Port: Designed to connect with the USB port of a computer for monitoring
and configuring the switch. The switch has an RJ-45 console port and a micro-USB console
port available. Console input is active on only one console port at a time. By default, the
micro-USB connector takes precedence over the RJ-45 connector.
 10/100/1000Mbps RJ45 Ports: Designed to connect to the device with a bandwidth of
10Mbps, 100Mbps or 1000Mbps. Each 10/100/1000Mbps RJ45 port has a corresponding
10/100/1000M LED.
 SFP Ports: Designed to install the SFP module. T2500G-10TS features 2 individual SFP
ports and supports 1000M SFP module connection only.
2.2.2 Rear Panel
The rear panel of T2500G-10TS features a power socket and a Grounding Terminal (marked
with
).
Figure 2-2 Rear Panel
 Kensington Security Slot: Secure the lock (not provided) into the security slot to prevent
the device from being stolen.
 Grounding Terminal: T2500G-10TS already comes with Lightning Protection Mechanism.
You can also ground the switch through the PE (Protecting Earth) cable of AC cord or with
Ground Cable. For detail information, please refer to Installation Guide.
 AC Power Socket: Connect the female connector of the power cord here, and the male
connector to the AC power outlet. Please make sure the voltage of the power supply meets
the requirement of the input voltage (100-240V~ 50/60Hz 0.2A).
Return to CONTENTS