TP-Link T2500G-10TS - Chapter 12 Network Security; 12.1 IP-MAC Binding

175
Rule ID:
Enter the rule ID.
Operation:
Select the operation for the switch to process packets which match
the rules.
 Permit: Forward packets.

Deny: Discard Packets.
S-MAC:
Enter the source MAC address contained in the rule.
D-MAC:
Enter the destination MAC address contained in the rule.
MASK:
Enter MAC address mask. If it is set to 1, it must strictly match the
address.
VLAN ID:
Enter the VLAN ID contained in the rule.
EtherType:
Enter EtherType contained in the rule.
User Priority: Select the user priority conta
ined in the rule for the tagged packets
to match.
Time-Range:
Select the time-range for the rule to take effect.
11.2.4 Standard-IP ACL
Standard-IP ACLs analyze and process data packets based on a series of match conditions,
which can be the source IP addresses and destination IP addresses carried in the packets.
Choose the menu ACL→ACL Config→Standard-IP ACL to load the following page.
Figure11-7 Create Standard-IP Rule
The following entries are displayed on this screen:

Create Standard-IP Rule
ACL ID:
Select the desired Standard-IP ACL for configuration.
Rule ID:
Enter the rule ID.