TP-Link T2500G-10TS - RADIUS Server Config

214
12.5.3 RADIUS Server Config
This page is used to configure the authentication servers running the RADIUS security
protocols.
Choose the menu Network Security→AAA→RADIUS Conifg to load the following page.
Figure 12-3 RADIUS Server Config

Configuration Procedure:
Configure the RADIUS server’s IP and other relevant parameters under the Server Config.
View, edit and delete the configured RADIUS servers in the Server list.

Entry Description:
Server IP:
Enter the IP of the server running the RADIUS secure protocol.
Shared Key:
Enter the shared key between the RADIUS server and the switch.
The RADIUS server and the switch use the key string to encrypt
passwords and exchange responses.
Auth Port:
Specify the UDP destination port on the RADIUS server for
authentication requests.
Acct Port:
Specify the UDP destination port on the RADIUS server for
accounting requests.
Retransmit:
Specify the number of times a request is resent to a server if the
server does not respond.
Timeout:
Specify the time interval that the switch waits for the server to
reply before resending.