TP-Link T2500G-10TS - Page 233

223

Port Config
Port Select: Click the Select button to quick-
select the corresponding port
based on the port number you entered.
Select:
Select the desired port for configuration. It is multi-optional.
Port:
Displays the port number.
Circuit-ID: Select Enable/Disable the PPPoE Circuit-ID Insertion feature
for the port.
Circuit-ID Type: Specify the Circuit-ID type for the port:
• IP: The IP address of the switch will be used to encode the
Circuit-ID option. This is the default value.
• MAC: The MAC address of the switch will be used to
encode the Circuit-ID option.
• UDF: The user specified string with the maximum length of
40 characters will be used to encode the Circuit-ID option.
• UDF-ONLY: The Circuit-ID option only contains user
specified strings. The maximum length of the strings is 40
characters.
UDF Value: If the UDF is selected, specify a string with the maximum length
of 40 characters to encode the Circuit-id option.
Remote-ID: Select Enable/Disable the PPPoE Remote-ID Insertion feature
for the port.
Remote-ID Value:
A user specified string with the maximum length of 40.
Return to CONTENTS