TP-Link T2500G-10TS - SNMP Group

228

View Config
View Name:
Give a name to the View for identification. Each View can
include several entries with the same name.
MIB Object ID:
Enter the Object Identifier (OID) for the entry of View.
View Type:
Select the type for the view entry.
• Include:
The view entry can be managed by the SNMP
management station.
• Exclude: The view entry cannot
be managed by the
SNMP management station.

View Table
Select:
Select the
desired entry to delete the corresponding view.
All the entries of a View will be deleted together.
View Name:
Displays the name of the View entry.
View Type:
Displays the type of the View entry.
MIB Object ID:
Displays the OID of the View entry.
13.1.3 SNMP Group
On this page, you can configure SNMP Group to control the network access by providing the
users in various groups with different management rights via the Read View, Write View and
Notify View.
Choose the menu SNMP→SNMP Config→SNMP Group to load the following page.
Figure 13-5 SNMP Group
The following entries are displayed on this screen:

Group Config
Group Name:
Enter the SNMP Group name. The Group Name, Security Model
and Security Level compose the identifier of the SNMP Group.