TP-Link T2500G-10TS - Page 245

235
Security Level:
Select the Security Level for the SNMP v3 User.
• noAuthNoPriv:
No authentication and no privacy security
level are used.
• authNoPriv: Only the authentication securit
y level is
used.
• authPriv:
Both the authentication and the privacy
security levels are used.
Type:
Select the type for the notifications.
• Trap: Indicates traps are sent.
• Inform:
Indicates informs are sent. The Inform type has a
higher security than the Trap type.
Retry:
Specify the amount of times the switch resends an inform
request. The switch will resend the inform request if it
doesn’t get the response from the management station
during the Timeout
interval, and it will terminate resending
the inform
request if the resending times reach the specified
Retry times.
Timeout:
Specify the maximum time for the switch to wait for the
response from the management station before resending a
request.

Notification Table
Select:
Select the desired entry to dele
te the corresponding
management station.
IP Mode:
Select the IP mode.
IP Address:
Displays the IP Address of the management host.
UDP Port:
Displays the UDP port used to send notifications.
User:
Displays the User name of the management station.
Security Model:
Displays the Security Model of the management station.
Security Level:
Displays the Security Level for the SNMP v3 User.
Type:
Displays the type of the notifications.
Timeout:
Displays the maximum time for the switch to wait for the
response
from the management station before resending a
request.
Retry:
Displays the amount of times the switch resends an inform
request.
Operation:
Click the Edit
button to modify the corresponding entry and
click the Modify button to apply.