TP-Link T2500G-10TS - Basic Config; Global Config

245
TLV
Description
Power Via MDI TLV The Power V
ia MDI TLV allows network management to
advertise and discover the MDI power support capabilities of
the sending IEEE 802.3 LAN station.
The LLDP module is mainly for LLDP function configuration of the switch, including three
submenus: Basic Config, Device Info and Device Statistics.
14.1 Basic Config
LLDP is configured on the Global Config and Port Config pages.
14.1.1 Global Config
On this page you can configure the LLDP parameters of the device globally.
Choose the menu LLDP→Basic Config→Global Config to load the following page.
Figure 14-1 Global Configuration
The following entries are displayed on this screen:

Global Config
LLDP:
Enable/disable LLDP function globally.

Parameters Config
Transmit Interval: Enter the
interval for the local device to transmit LLDPDU to its
neighbors. The default value is 30 seconds.
Hold Multiplier:
Enter a multiplier on the Transmit Interval. It determines the
actual TTL (Time To Live) value used in an LLDPDU. TTL = Hold
Multiplier * Transmit Interval. The default value is 4.