TP-Link T2500G-10TS - Chapter 15 Maintenance; 15.1 System Monitor

247
Admin Status: Select the port’s LLDP operating mode:
 Tx&Rx: Send and receive LLDP frames.
 Rx_Only: Only receive LLDP frames.
 Tx_Only: Only send LLDP frames.

Disable: Neither send nor receive LLDP frames.
Notification Mode: Enable/Disable the ports' SNMP
notification. If enabled, the local
device will notify the trap event to SNMP server.
Included TLVs:
Select TLVs to be included in outgoing LLDPDU.
Details:
Click Details to display the included TLVs.
14.2 Device Info
You can view the LLDP information of the local device and its neighbors on the Local Info and
Neighbor Info pages respectively.
14.2.1 Local Info
On this page you can see all ports' configuration and system information.
Choose the menu LLDP→Device Info→Local Info to load the following page.
Figure 14-3 Local Information