TP-Link T2500G-10TS - Neighbor Info

255
Device Type:
Specify the auto refresh rate.
Application Type:
Application Type indicates the primary function of the
applications defined for the network policy.
Unknown Policy
Flag:
Displays whether the local device will explicitly advertise the
policy required by the device but currently unknown.
VLAN tagged:
Indicates the VLAN type the specified application type is using,
'tagged' or 'untagged'.
Media Policy VLAN
ID:
Displays the application (eg. Voice VLAN) VLAN identifier (VID)
for the port.
Media Policy Layer
2 Priority:
Displays the Layer
2 priority to be used for the specified
application type.
Media Policy DSCP:
Displays the DSCP value to be used to provide Diffserv node
behavior for the specified application type as defined in IETF
RFC 2474.
14.4.4 Neighbor Info
On this page you can get the LLDP-MED information of the neighbors.
Choose the menu LLDP→LLDP-MED→Neighbor Info to load the following page.
Figure 14-10 LLDP-MED Neighbor Information
The following entries are displayed on this screen
:

Auto Refresh
Auto Refresh:
Enable/Disable the auto refresh function.
Refresh Rate:
Specify the auto refresh rate.

LLDP-MED Neighbor Info
Select the desired port to display LLDP-MED information of neighbors of the
corresponding port:
Device Type:
Displays the device type of the neighbor.