TP-Link T2500G-10TS - Page 279

269
Web Refresh State:
Enable/Disable the web automatic refresh function.
Web Refresh
Interval:
Configure the interval to refresh the web page, ranging from 1
to 100 seconds, and the default value is 5 seconds.

Port Config
Port Select: Click the Select button to quick-selec
t the corresponding port
based on the port number you entered.
Select:
Select the desired port for configuration. It is multi-optional.
Port:
Port list of the switch.
DLDP State:
Enable/Disable DLDP on the selected port.
Protocol State:
Displays the DLDP protocol state.
Link State:
Displays the state of the links.
Neighbor State:
Displays the state of the selected port’s neighbor.
Configuration Procedure:
Step
Operation
Description
1 Enable DLDP globally. Required. On the Maintenance→DLDP→DLDP page,
configure DLDP State as Enable under the Global Config
tab.
2
Enable DLDP on the
specified port.
Required. On the Maintenance→DLDP→DLDP page,
configure DLDP State as Enable on specified port in the
Port Config table.
3 Configure Shut Mode. Optional. On the Maintenance→DLDP→DLDP page,
configure the Shut Mode as Auto or Manual under the
Global Config tab.
4 Reset DLDP state. Optional. On the Maintenance→DLDP→DLDP page, select
the specified ports or select all the ports in the Port Config
table and click the Reset button to restore their state.