TP-Link T2500G-10TS - HTTP Config

31
Choose the menu System→Access Security→Access Control to load the following page.
Figure 4-19 Access Control
The following entries are displayed on this screen:

Access Control Config
Control Mode:
Select the control mode for users to log on to the Web
management page.
 IP-based: Select this option to limit the IP-
range of the users
for login.
 MAC-based:
Select this option to limit the MAC Address of
the users for login.

Port-based: Select this option to limit the ports for login.
Access Interface：
Select the interface for access control to apply.
IP Address & Mask
：
These fields is available to configure only when IP-
based mode
is selected. Only the users within the IP-
range you set here are
allowed for login.
MAC Address: The field can be avail
able for configuration only when
MAC-
based mode is selected. Only the user with this MAC
Address you set here is allowed for login.
Port:
The field can be available for configuration only when
Port-
based mode is selected. Only the users connected to
these ports you selected here are allowed for login.
4.4.2 HTTP Config
With the help of HTTP (Hyper Text Transfer Protocol), you can manage the switch through a
standard browser. The standards development of HTTP was coordinated by the Internet
Engineering Task Force and the World Wide Web Consortium.
On this page you can configure the HTTP function.