TP-Link T2500G-10TS - Page 47

37
The following entries are displayed on this screen
:

Global Config
SSH:
Select Enable/Disable SSH function.
Protocol V1:
Select Enable/Disable SSH V1 to be the supported protocol.
Protocol V2:
Select Enable/Disable SSH V2 to be the supported protocol.
Idle Timeout: Specify the idle timeout time. The system will aut
omatically
release the connection when the time is up. The default time is
120 seconds.
Max Connect:
Specify the maximum number of the connections to the SSH
server. No new connection will be established when the number
of the connections reaches the maxi
mum number you set. The
default value is 5.

Encryption Algorithm
Configure SSH encryption algorithms.
AES128-CBC: Select the checkbox to enable the AES128-
CBC algorithm of
SSH.
AES128-CBC: Select the checkbox to enable the AES128-
CBC algorithm of
SSH.
AES192-CBC: Select the checkbox to enable the AES192-
CBC algorithm of
SSH.
AES256-CBC: Select the checkbox to enable the AES256-
CBC algorithm of
SSH.
Blowfish-CBC: Select the checkbox to enable the Blowfish-
CBC algorithm of
SSH.
Cast128-CBC: Select the checkbox to enable the Cast128-
CBC algorithm of
SSH.
3DES-CBC:
Select the checkbox to enable the 3DES-CBC algorithm of SSH.

Data Integrity Algorithm
Configure SSH data integrity algorithms.
HMAC-SHA1: Select the checkbox to enable the HMAC-SHA1 algorit
hm of
SSH.
HMAC-MD5: Select the checkbox to enable the HMAC-
MD5 algorithm of
SSH.