TP-Link T2500G-10TS - Application Example for 802.1 Q VLAN

79
Note:
The Protocol Template bound to VLAN cannot be deleted.
Configuration Procedure:
Step
Operation
Description
1 Set the link type for port. Required. On the VLAN→802.1Q VLAN→Port Config page,
set the link type for the port basing on its connected
device.
2 Create VLAN. Required. On the VLAN→802.1Q VLAN→VLAN Config
page, click the Create button to create a VLAN. Enter the
VLAN ID and the description for the VLAN. Meanwhile,
specify its member ports.
3 Create Protocol Template. Required. On the VLAN→Protocol VLAN→Protocol
Template page, create the Protocol Template before
configuring Protocol VLAN.
4 Create Protocol VLAN. Required. On the VLAN→Protocol VLAN→Protocol
Group
page, select the protocol name and enter the
VLAN ID to create a Protocol VLAN. Meanwhile, enable
protocol VLAN for ports.
5 Modify/View VLAN. Optional. On the VLAN→Protocol VLAN→Protocol
Group Table page, click the Edit button to modify/view
the information of the corresponding VLAN.
6 Delete VLAN. Optional. On the VLAN→Protocol VLAN→Protocol
Group Table page, select the desired entry to delete the
corresponding VLAN by clicking the Delete button.
6.4 Application Example for 802.1Q VLAN
 Network Requirements
 Switch A is connecting to PC A and Server B;
 Switch B is connecting to PC B and Server A;
 PC A and Server A is in the same VLAN;
 PC B and Server B is in the same VLAN;
 PCs in the two VLANs cannot communicate with each other.