TP-Link T2500G-10TS - Application Example for Protocol VLAN

82
Step
Operation
Description
6 Port Enable Required. On the VLAN→MAC VLAN→Port Enable page, select and
enable Port 11 and Port 12 for MAC VLAN feature.
 Configure switch B
Step
Operation
Description
1
Configure the
Link Type of the
ports
Required. On VLAN→802.1Q VLAN→Port Config page, configure the
link
type of Port 21 and Port 22 as GENERAL and TRUNK
respectively.
2 Create VLAN10 Required. On VLAN→802.1Q VLAN→VLAN Config
page, create a
VLAN with its VLAN
ID as 10, owning Port 21 and Port 22, and
configure the egress rule of Port 21 as Untag.
3 Create VLAN20 Required. On VLAN→802.1Q VLAN→VLAN Config
page, create a
VLAN with its VLAN
ID as 20, owning Port 21 and Port 22, and
configure the egress rule of Port 21 as Untag.
4
Configure MAC
VLAN 10
On VLAN→MAC VLAN→MAC VLAN page, create MAC VLAN10 with
the MAC address as 00-19-56-8A-4C-71.
5
Configure MAC
VLAN 20
On VLAN→MAC VLAN→MAC VLAN page, create MAC VLAN10 with
the MAC address as 00-19-56-82-3B-70.
6 Port Enable Required. On the VLAN→MAC VLAN→Port Enable page, select and
enable Port 21 and Port 22 for MAC VLAN feature.
 Configure switch C
Step
Operation
Description
1
Configure the
Link Type of the
ports
Required. On VLAN→802.1Q VLAN→Port Config page, configure the
link type of Port 2 and Port 3 as GENERAL, and configure the link type
of Port 4 and Port 5 as ACCESS.
2 Create VLAN10 Required. On VLAN→802.1Q VLAN→VLAN Config
page, create a
VLAN with its VLAN ID as 10, owning Port 2, Port 3 and Port 5,
3 Create VLAN20 Required. On VLAN→802.1Q VLAN→VLAN Config
page, create a
VLAN with its VLAN ID as 20, owning Port 2, Port 3 and Port 4,
6.6 Application Example for Protocol VLAN
 Network Requirements
 Department A is connected to the company LAN via Port12 of switch A;
 Department A has IP host and AppleTalk host;