TP-Link T2600G-28TS - Page 176

164
Figure 9-17 Multicast VLAN Config
The following entries are displayed on this screen:

Multicast VLAN
Multicast VLAN: Select Enable/Disable Multicast VLAN feature.
VLAN ID: Enter the VLAN ID of the multicast VLAN.
Router Port Time:
Specify the aging time of the router port. Within this time, if the
switch doesn’
t receive IGMP query message from the router port,
it will consider this port is not a router port any more.
Member Port Time:
Specify the aging time of the member port. Within this time, if the
switch doesn’
t receive IGMP report message from the member
port, it will consider this port is not a member port any more.
Replace Source IP: Specify the IP address with
which the switch will replace the
source of MLD packets.
Dynamic Router
Ports:
Displays the dynamic router ports of the multicast VLAN.
Static Router Ports: Specify
the static router port which is mainly used in the network
with stable topology.