TP-Link T2700G-28TQ - Show Monitor Session

T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
195
Delete the Gigabit Ethernet port 4 in monitor session 1 and its configuration:
T2700G-28TQ(config)#no monitor session 1 source interface
gigabitEthernet 1/0/4 rx
show monitor session
Description
The show monitor session command is used to display the configuration of
port monitoring.
Syntax
show monitor session [session_num]
Parameter
session_num —— The monitor session number, the value of which is 1.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the monitoring configuration of monitor session 1:
T2700G-28TQ(config)#show monitor session 1