TP-Link T2700G-28TQ - Access-List Bind(Interface); Access-List Bind(Vlan)

T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
214
priority —— Local Priority of QoS Remark. Specify the local priority for the data
packets matching the corresponding ACL. Local Priority ranges from 0 to 7.
Command Mode
Action Configuration Mode
Example
Edit the actions for policy1. For the data packets matching ACL 1200, specify
the DSCP region as 30 and local priority 2:
T2700G-28TQ(config)#access-list policy action policy1 1200
T2700G-28TQ(config-action)# qos-remark dscp 30 priority 2
access-list bind(interface)
Description
The access-list bind command is used to bind a policy to a specified port. To
cancel the bind relation, please use no access-list bind command.
Syntax
access-list bind policy-name
no access-list bind policy-name
Parameter
policy-name —— The name of the policy desired to bind.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Bind policy1 to Gigabit Ethernet port 1/0/2:
T2700G-28TQ(config)#interface gigabitEthernet 1/0/2
T2700G-28TQ(config-if)#access-list bind policy1
access-list bind(vlan)
Description
The access-list bind command is used to bind a policy to a VLAN. To cancel
the bind relation, please use no access-list bind command.