TP-Link T2700G-28TQ - Permit; Range

T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
322
T2700G-28TQ(config)# ip igmp profile 1
T2700G-28TQ(config-igmp-profile)#deny
permit
Description
The permit command is used to configure the filtering mode of profile as permit.
Syntax
permit
Command Mode
Profile Configuration Mode
Example
Configure the filtering mode of profile 1 as permit:
T2700G-28TQ(config)# ip igmp profile 1
T2700G-28TQ(config-igmp-profile)#permit
range
Description
The range command is used to configure the range of the profile’s filtering
multicast address. To delete the corresponding filtering multicast address,
please use no range command.
Syntax
range start-ip [end-ip]
no range start-ip [end-ip]
Parameter
start-ip —— The start filtering multicast IP address.
end-ip —— The end filtering multicast IP address.
Command Mode
Profile Configuration Mode