TP-Link T2700G-28TQ - Switch Stack-Port; Show Switch

T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
32
Example
Specify the name of the stack as Stack1:
T2700G-28TQ(config)# switch stack-name Stack1
switch stack-port
Description
The switch stack-port command is used to enable the stack port. To switch the
stack port to Ethernet port, please use no switch stack-port command.
Syntax
swtich stack-port interface ten-gigabitEthernet port
no switch stack-port interface ten-gigabitEthernet port
Parameter
port —— The stack port number.
Command Mode
Global Configuration Mode
Example
Specify the ten-gigabit port 1/1/2 as stack port when the Interface Card is
installed:
T2700G-28TQ(config)# switch stack-port interface ten-gigabitEthernet
1/1/2
show switch
Description
The show switch command is used to display the current stack’s information.
Syntax
show switch [ unitid | detail | neighbor | stack-ports ]
Parameter
unitid —— Specify the member number.