41
6. How to configure a PPTP Server on TP-LINK Router
Suitable for: TL-ER6120, TL-ER6020, TL-ER604W
PPTP (Point to Point Tunneling Protocol) Server is used to create a VPN connection for
remote clients. To configure PPTP Server on TP-LINK router, please follow the instructions
below:
A. Make sure PCs of two sides can access to Internet
B. Configuring a PPTP Server on TP-LINK router
C. Configuring PPTP client on remote PC (Windows 7)
NOTE: If the TP-LINK Router is behind a NAT device, Virtual Server or DMZ should be
configured on the NAT device, otherwise the VPN tunnel can’t be established.
A. Make sure PCs of two sides can access to Internet
Before setup a VPN tunnel, you need to ensure that PCs of two sides are connected to the
Internet. After ensuring that there is an active Internet connection on each side, you need to
verify the VPN settings of the two sides, please follow the instruction below.
B. Configuring a PPTP Server on TP-LINK router
Step 1:
Access the router’s management webpage, verify the settings needed on the router.
To Next Page
Loading...
