43
2) If the IP addresses in the IP Address Pool is in the same subnet with the VPN router’s LAN
port, the remote VPN clients can directly access the Internet. It’s recommended that the IP
address range in the IP Address Pool do not overlap with the one in the local DHCP IP
address pool. If not in the same subnet, it must configure an extra multi-nets NAT entry.
Only in this way, the remote VPN clients can access the Internet via the VPN router in the
headquarters. The following contents will respectively introduce the two situations.
In the Same Subnet
1) Configure the IP Address Pool of access router A as step 2.
2) Keep using the default gateway on remote network on clients, as the steps in the
following picture.
In the Different Subnet
1) Configure the IP Address Pool of access router A as step 1.
To Next Page
Loading...
