Connect TL-MR3220 to WAN network ●
Power off the ADSL/Cable Modem.1)
Connect the notebook/PC to the LAN port of TL-MR3220 with an 2)
Ethernet cable. Connect the ADSL/Cable Modem to the WAN port of
TL-MR3220 with an Ethernet cable.
Plug the power adapter into the power jack of TL-MR3220.3)
Power on the modem and wait until all LEDs fl ash properly. Press 4)
the ON/OFF button to power on TL-MR3220.
We recommend you to use only the Power Adapter 1.
provided with the device.
Place the device on the level and stable surface.2.
Unplug the Power Adapter in the thunder storm to avoid 3.
damage.
Place the device in a well ventilated place far from any 4.
heater or heating vent.
Keep the router far from the water to avoid damage.5.
Warning
To Next Page
Loading...
