Configuring Firewall Configuration Examples
Configuration Guide
99
3.2.2 Configuration Scheme
To meet this requirement, we can configure MAC Filtering on the router to filter the packets
with the MAC address of the attacker. The configuration overview is as follows:
1) Enable MAC Filtering globally and select the filtering rule as “Deny packets with the MAC
addresses listed below and allow the rest“.
2) Add the MAC address of the attacker to the MAC Filtering List.
3.2.3 Configuration Procedure
Follow the steps below to configure MAC Filtering on the router:
1) Choose the menu Firewall > MAC Filtering > MAC Filtering to load the following page. In
the General section, enable MAC Filtering and select the filtering rule as “Deny packets with
the MAC addresses listed below and allow the rest“. Click Save.
Figure 3-2 Enable MAC Filtering
2) In the MAC Filtering List section, click Add. Specify a name for this entry and enter the
attacker’s MAC address. Click OK.
Figure 3-3 Add MAC Filtering Entry
To Next Page
Loading...
