Configuration Guide 102
Configuring Firewall Configuration Examples
Figure 3-4 Configure HTTPS Service Type
4) Choose the menu Firewall > Access Control > Access Control to load the configuration
page, and click Add. Specify a name for this rule. Select “Allow” as the rule policy, “HTTP”
as the service type, “LAN” as the effective interface, “RD_Dept” as the source IP group,
“IPGROUP_ANY” as the destination IP group, and “Any” as the effective time. Click OK.
This rule means that all the HTTP packets from the R&D department are allowed to be
transmitted from LAN to the internet at any time.
Figure 3-5 Configure Allow Rule for HTTP Service
5) Choose the menu Firewall > Access Control > Access Control to load the configuration
page, and click Add. Specify a name for this rule. Select “Allow” as the rule policy, “HTTPS”
as the service type, “LAN” as the effective interface, “RD_Dept” as the source IP group,
“IPGROUP_ANY” as the destination IP group, and “Any” as the effective time. Click OK.
This rule means that all the HTTPS packets from the R&D department are allowed to be
sent from the LAN to the internet at any time.
To Next Page
Loading...
