Configuring Firewall Configuration Examples
Configuration Guide
103
Figure 3-6 Configure Allow Rule for HTTPS Service
6) Choose the menu Firewall > Access Control > Access Control to load the configuration
page, and click Add. Specify a name for this rule. Select “Allow” as the rule policy, “DNS”
as the service type, “LAN” as the effective interface, “RD_Dept” as the source IP group,
“IPGROUP_ANY” as the destination IP group, and “Any” as the effective time. Click OK.
This rule means that all DNS packets from the R&D department are allowed to be sent
from the LAN to the internet at any time.
Figure 3-7 Configure Allow Rule for DNS Service
7) Choose the menu Firewall > Access Control > Access Control to load the configuration
page, and click Add. Specify a name for this rule. Select “Block” as the rule policy, “ALL”
as the service type, “LAN” as the effective interface, “RD_Dept” as the source IP group,
“IPGROUP_ANY” as the destination IP group, and “Any” as the effective time. Click OK.
To Next Page
Loading...
