Configuration Guide 112
Configuring Behavior Control Behavior Control Configuration
2.2 Configuring Web Security
Before configuring Web Security, go to Preferences module to configure the IP Group and
Effective Time according to your needs.
Choose the menu Behavior Control > Web Security > Web Security and click Add to load
the following page.
Figure 2-4 Web Security Page
Follow the steps below to configure Web Security.
1) In the Web Security List section, configure the following parameters and click OK to add a
Web Security rule.
IP Group Select an IP group for the rule. The IP group referenced here can be
created on the Preferences > IP Group page.
Block HTTP Post With this option enabled, HTTP posts will be blocked. The hosts of the
selected IP group cannot log in, submit comments or do any operation
using HTTP post.
To Next Page
Loading...
