Configuration Guide 152
Managing Services UPnP Configuration
3
UPnP Configuration
Choose the menu Service > UPnP to load the following page.
Figure 3-1 Configure UPnP Function
Follow these steps to configure UPnP function:
1) In the General section, enable the UPnP function and select the interface. Then click
Save.
Enable UPnP Check the box to enable the UPnP function.
Interface Select the interface for the UPnP function.
2) (Optional) In the UPnP Portmap List section, view the portmap list.
Description Displays the description of the application using UPnP protocol.
Protocol Displays the protocol type used in the process of UPnP.
Interface Displays the interface used in the process of UPnP.
IP Address Displays the IP address of the local host.
External Port Displays the external port that is opened for the application by the router.
Internal Port Displays the internal port that is opened for the application by the local host.
Status Displays the status of the corresponding UPnP entry.
Enabled: The mapping is active.
Disabled: The mapping is inactive.
To Next Page
Loading...
