Configuration Guide 44
Configuring Network IPv6 Configuration
Configuring the 6to4 Tunnel
6to4 is an internet transition mechanism for migrating from IPv4 to IPv6, a system that
allows IPv6 packets to be transmitted over an IPv4 network. The IPv6 packet will be
encapsulated in the IPv4 packet and transmitted to the IPv6 destination through IPv4
network.
Figure 8-5 Configuring the 6to4 Tunnel
Follow these steps to configure 6to4 Tunnel connection:
1) In the General section, check the box to enable IPv6 function, then click Save.
IPv6 Check the box to enable IPv6 function.
2) In the Internet section, choose the Internet Connection type as 6to4 Tunnel, and
configure the corresponding parameters. Then click Save.
Internet
Connection Type
Choose the connection type as PPPoE.
IPv4 Address/
IPv4 Subnet
Mask/IPv4
Default Gateway
These parameters will be dynamically generated by the IPv4 information of WAN
port after you click Connect.
Tunnel Address Displays the tunnel address of the WAN port.
To Next Page
Loading...
