Configuring VPN IPSec VPN Configuration
Configuration Guide
127
2
IPSec VPN Configuration
To complete the IPSec VPN configuration, follow these steps:
1) Configure the IPSec Policy.
2) Verify the connectivity of the IPSec VPN tunnel.
Configuration Guidelines
For both ends of the VPN tunnel, the Pre-shared key, Proposal, Exchange Mode, and
Encapsulation Mode should be identical.
For both ends of the VPN tunnel, the Remote Gateway, Local/Remote Subnet, Local/
Remote ID Type should be matched.
2.1 Configuring the IPSec Policy
2.1.1 Configuring the Basic Parameters
Choose the menu VPN > IPSec > IPSec Policy and click Add to load the following page.
Figure 2-1 Configuring the Basic Parameters
Follow these steps to configure the basic parameters:
1) Specify the name of the IPSec Policy.
2) Configure the Network Mode. Select LAN-to-LAN when the network is connected to
the other network. Select Client-to-LAN when a host is connected to the network.
To Next Page
Loading...
