Configuring VPN L2TP Configuration
Configuration Guide
133
Note:
•
The starting IP address should not be greater than the ending IP address.
•
The ranges of IP Pools cannot overlap.
3.2 Configuring L2TP Globally
Choose the menu VPN> L2TP > Global Config to load the following page.
Figure 3-2 Configuring L2TP Globally
In the General section, configure L2TP parameters globally and click Save.
L2TP Hello
Interval
Specify the time interval of sending L2TP peer detect packets.
PPP Hello
Interval
Specify the time interval of sending PPP peer detect packets.
NetBIOS
Passthrough
Enable NetBIOS Passthrough function to allow NetBIOS packets to be broadcasted
through VPN tunnel.
3.3 Configuring the L2TP Server
Choose the menu VPN> L2TP > L2TP Server and click Add to load the following page.
Figure 3-3 Configuring the L2TP Server
To Next Page
Loading...
