Configuring VPN L2TP Configuration
Configuration Guide
137
Network Mode Specify the network mode. There are two modes:
Client-to-LAN: Select this option when the L2TP/PPTP client is a single host.
LAN-to-LAN: Select this option when the L2TP/PPTP client is a VPN gateway. The
tunneling request is always initiated by a device.
Max
Connections
Specify the maximum number of connections that the tunnel can support.
Remote Subnet Specify a remote network. (This is the IP address range of the LAN on the remote
peer of the L2TP/PPTP tunnel.) It’s the combination of IP address and subnet mask.
3) Click OK.
3.6 Verifying the Connectivity of L2TP VPN Tunnel
Choose the menu VPN> L2TP > Tunnel List to load the following page.
Figure 3-6 L2TP VPN Tunnel List
The Tunnel List shows the information of the established L2TP VPN tunnel.
Account Name Displays the account name of L2TP tunnel.
Mode Displays whether the device is server or client.
Tunnel Displays the name of the tunnel when the router is a L2TP client.
Local IP Displays the local IP address of the tunnel.
Remote IP Displays the remote real IP address of the tunnel.
Remote Local
IP
Displays the remote local IP address of the tunnel.
DNS Displays the DNS address of the tunnel.
To Next Page
Loading...
