Configuring VPN PPTP Configuration
Configuration Guide
141
MPPE
Encryption
Specify whether to enable the encryption for the tunnel. If enabled, the PPTP tunnel
will be encrypted by MPPE.
Remote Subnet Specify the remote network. (It’s always the IP address range of LAN on the remote
peer of the VPN tunnel.) It’s the combination of IP address and subnet mask.
Upstream
Bandwidth
Specify the uptream limited rate in Kbps for PPTP tunnel.
Downstream
Bandwidth
Specify the downstream limited rate in Kbps for PPTP tunnel.
Working Mode Specify the Working Mode as NAT or Routing.
NAT: NAT (Network Address Translation) mode allows the router to translate
source IP address of PPTP packets to its WAN IP when forwarding PPTP packets.
Route: Route mode allows the router to forward PPTP packets via routing protocol.
Status Check the box to enable the PPTP tunnel.
2) Click OK.
4.5 Configuring the PPTP Users
Choose the menu VPN> Users > Users and click Add to load the following page.
Figure 4-5 Configuring the PPTP User
Follow these steps to configure the PPTP User:
1) Specify the account name and password of the PPTP User.
To Next Page
Loading...
