Configuring VPN Configuration Examples
Configuration Guide
149
5.2.2 Configuration Scheme
To meet the requirements, configure L2TP server on the router, and configure L2TP client
on the remote PC. For the remote PC, use Windows built-in L2TP software or third-party
L2TP software to connect to L2TP server. Then verify whether the L2TP VPN tunnel is
established successfully.
The following section provides the configuration procedure.
5.2.3 Configuration Procedure
Follow the steps below to configure L2TP VPN on the router and PC:
Configuring the router
1) Choose the menu Preferences > VPN IP Pool > VPN IP Pool to load the configuration
page, and click Add. Specify the pool name as VPN_Pool, and enter the starting/ending
IP address.
Figure 5-12 Configuring the VPN IP Pool
2) Choose the menu VPN> L2TP > Global Config to load the following page. You can keep
the L2TP/PPP hello interval as the default value.
Figure 5-13 Configuring L2TP Globally
3) Choose the menu VPN> L2TP > L2TP Server to load the configuration page, and
click Add. Specify WAN1 as the outgoing interface of L2TP VPN tunnel, enable IPSec
encryption and specify the pre-shared key as 123456.
To Next Page
Loading...
