Configuring Authentication Onekey Online Configuration
Configuration Guide
169
4
Onekey Online Configuration
In Onekey Online authentication, users only need to click the “Onekey online” button on the
authentication page, then can access the internet. The username and password are not
required.
4.1 Configuring the Authentication Page
Choose the menu Authentication > Authentication Settings > Web Authentication to
load the following page. Please make sure that the Authentication Type is configured as
Onekey Online.
Figure 4-1 Configuring the Web Authentication
Follow these steps to configure Onekey Online Authentication:
1) In the Settings section, enable the authentication status, configure the idle timeout and
portal authentication port.
Status Check the box to enable portal authentication.
Idle Timeout Specify the idle timeout. The client will be disconnected after the specified
period (Idle Timeout) of inactivity, and is required to be authenticated again.
Value 0 means the client will always keep online until the authentication timeout
leased, even if the client remains inactive.
Portal
Authentication
Port
Enter the service port for portal authentication. The default setting is 8080.
To Next Page
Loading...
