Configuring Authentication Guest Resources Configuration
Configuration Guide
171
5
Guest Resources Configuration
Guest resources are limited network resources provided for users before they pass the
portal authentication.
You can configure the guest resources in two ways:
Five Tuple Type
Specify the client and the network resources the client can visit based on the settings of
IP address, MAC address, VLAN ID, service port and protocol. It is recommended to select
Five Tuple Type when the IP address and service port of the free network resource are
already known.
URL Type
Specify the client and the network resources the client can visit based on the settings of
the URL, IP address, MAC address and service port. It is recommended to select URL Type
when the URL of the free network resource is already known.
Note:
By default, the Guest Resource table is empty, which means all the clients cannot visit any network
resource before they pass the portal authentication.
5.1 Configuring the Five Tuple Type
Choose the menu Authentication > Authentication Settings > Guest Resources and click
Add to load the following page.
To Next Page
Loading...
