System Tools SNMP
Configuration Guide
197
4
SNMP
Choose the menu System Tools > SNMP > SNMP to load the following page.
Figure 4-1 Configuring SNMP
Follow these steps to configure the SNMP function:
1) Check the box to enable the SNMP function.
2) Configure the following parameters and click Save.
Contact Enter the textual identification of the contact person for this the device, for
example, contact or e-mail address.
Device Name Enter a name for the device.
Location Enter the location of the device. For example, the name can be composed of the
building, floor number, and room location.
Get Community Specify the community that has read-only access to the device’s SNMP
information.
Get Trusted
Host
Enter the IP address that can serve as Get Community to read the SNMP
information of this device.
Set Community Specify the community who has the read and write right of the device’s SNMP
information.
Set Trusted
Host
Enter the IP address that can serve as Set Community to read and write the SNMP
information of this device.
To Next Page
Loading...
