Configuration Guide 34
Configuring Network Switch Configuration
Ingress Frame
Type
Specify the ingress frame type to be limited. It is All Frames by default.
All Frames: The ingress rate of all frames is limited.
Broadcast: The ingress rate of broadcast frames is limited.
Broadcast and Multicast: The ingress rate of broadcast and multicast frames is
limited.
Ingress Rate
(Mbps)
Specify the limit rate for the ingress packets.
Egress Limit Check the box to enable Egress Limit feature.
Egress Rate
(Mbps)
Specify the limit rate for the egress packets.
6.4 Configuring Port Config
You can configure the flow control and negotiation mode for the port.
Choose the menu Network > Switch > Port Config to load the following page.
Figure 6-4 Configuring Flow Control and Negotiation
Configure the flow control and negotiation mode for a port.
Flow Control Check the box to enable the flow control function.
Flow Control is the process of managing the data transmission of the sender to avoid
the receiver getting overloaded.
To Next Page
Loading...
