Configuration Guide 82
Configuring Transmission Configuration Examples
7.3.2 Network Topology
Figure 7-9 Network Topology
Internet
PC
Router
FTP Server
IP:192.168.0.100
LAN
WAN1
7.3.3 Configuration Scheme
In this scenario, both virtual server and DMZ host can be configured to meet the
requirement. Here we take configuring Virtual Server as an example, owing to that for a
DMZ host all ports are open which may result in unsafety. Configure the FTP server as a
virtual server on the router so that the FTP server can be accessed by the internet user.
7.3.4 Configuration Procedure
Follow the steps below to configure virtual server on the router:
1) Choose the menu Network > NAT > Virtual Servers to load the configuration page, and
click Add.
2) Specify the entry name as ftp, choose the interface as WAN1, and specify the internal/
external port as 21, enter the IP address of FTP server (192.168.0.100) as the internal
server IP. Select the protocol as All, then keep Status of this entry as Enable. Click OK.
Figure 7-10 Configuring the Virtual Server
To Next Page
Loading...
