Configuration Guide 84
Configuring Transmission Configuration Examples
2) Specify the primary WAN as WAN1, the backup WAN as WAN2 and the mode as Failover
so that the backup link will be enabled when the primary WAN failed. Keep Status of this
entry as Enable. Click OK.
Figure 7-12 Configuring the Link Backup
Configuring the Policy Routing Rules
1) Choose the menu Preferences > IP Group > IP Address to load the configuration page,
and click Add. Specify the IP address name as tp, the IP address type as IP Address
Range (192.168.0.2-192.168.0.3). Click OK.
Figure 7-13 Configuring the IP Address
2) Choose the menu Preferences > IP Group > IP Address to load the configuration
page and click Add. Specify the IP group name as group1, the IP address name as tp to
reference the IP address you have created. Click OK.
Figure 7-14 Configuring the IP Group
To Next Page
Loading...
