Configuring Transmission Configuration Examples
Configuration Guide
85
3) Choose the menu Transmission > Routing > Policy routing to load the configuration
page, and click Add.
Specify the policy routing rule name as policy1, the service type as HTTP, the source IP
as group1, the destination IP as IPGROUP_ANY which means no limit. Choose WAN1,
and keep Status of this entry as Enable. Click OK.
Figure 7-15 Configuring the Policy Routing Rule 1
Specify the policy routing rule name as policy2, the service type as ALL, the source IP
as group1, the destination IP as IPGROUP_ANY which means no limit. Choose WAN2,
and keep Status of this entry as Enable. Click OK.
Figure 7-16 Configuring the Policy Routing Rule 2
To Next Page
Loading...
